R290 Green Gas at low GWP(3)
Good SCOP, energy label rating W35℃ A+++/ W55℃ A++
Smart logic to control multiple heat source
Climate curves suitable for different countries
Hot water up to 75C, suitable for underfloor/radiator heating/fan coil
Full inverter system, Stable and efficient performance
Space heating Series is specially developed with the most cutting-edge heat pump technology and modern design to meet stringent requirements for efficiency, stability and quietness. Not only does Space heating Series use R290 green gas, but also is rated with A+++ energy label. With top energy rating A+++, the unit is energy efficient and can greatly reduce energy bills for users.
R290 is one of the best refrigerant available for mass production upto now: Negligible Global Warming Potential(GWP) and degradation time is considered in monthes
Zero ozone layer depletion potential(ODP)
Permanent green
Less load for the same performance
Low energy consumption and higher efficiency
By heating the water in the system to 65°C, the high temperature kills most bacteria (including Legionella).
Eco mode is an intelligent energy-saving mode that can minimize energy consumption while ensuring comfortable temperatures, achieving green environmental protection for air source heat pumps.
Protect your home floor by activating the Floor Preheating function which slowly increases the heating temperature of the floor coils, avoiding possible floor damaging and transitioning smoothly to the heating function. The Floor Drying Up function provides an additional solution to the installer as it helps remove any residual moisture from newly installed floor coils, further protecting the installation and ensuring the optimal and effective operation of the heat pump.
More flexibility thanks to two control zones
Independent control of underfloor heating and radiator heating temperature
No need to purchase an extension module for second heating system
Smart design to work with other heating facilities in your house, like solar, gas boiler and etc, make sure you to pay the lowest bill for heating !
A heat pump system designed for a single area is intended to warm a small space, usually just one room. These systems consist of an outdoor unit that links to a single indoor unit, providing heating or cooling to the designated area.
If you only need to heat or cool a small part of your house, then a single-area heat pump system is the ideal choice. One common scenario where a single-area system is used is when you want to regulate the temperature in a newly built extension of your home, while the rest of the house is already equipped with a central air conditioning system. Although you have the option to install multiple single-area systems, if you want to heat or cool multiple rooms using air source heat pumps, it would be more energy-efficient to opt for a multi-area system.
A multi-zone heat pump system has the ability to warm and cool different parts of a house by using multiple units in various areas, all linked to a single outdoor unit. By installing a multi-zone system, you have the option to heat or cool different "zones" within your property at different temperatures simultaneously. For instance, during the scorching summer months, you can set the temperature of the room where you spend most of your time to a lower level, while other zones are set at a higher temperature to minimize your overall energy consumption.
R290 Green Gas at low GWP(3)
Good SCOP, energy label rating W35℃ A+++/ W55℃ A++
Smart logic to control multiple heat source
Climate curves suitable for different countries
Hot water up to 75C, suitable for underfloor/radiator heating/fan coil
Full inverter system, Stable and efficient performance
Space heating Series is specially developed with the most cutting-edge heat pump technology and modern design to meet stringent requirements for efficiency, stability and quietness. Not only does Space heating Series use R290 green gas, but also is rated with A+++ energy label. With top energy rating A+++, the unit is energy efficient and can greatly reduce energy bills for users.
R290 is one of the best refrigerant available for mass production upto now: Negligible Global Warming Potential(GWP) and degradation time is considered in monthes
Zero ozone layer depletion potential(ODP)
Permanent green
Less load for the same performance
Low energy consumption and higher efficiency
By heating the water in the system to 65°C, the high temperature kills most bacteria (including Legionella).
Eco mode is an intelligent energy-saving mode that can minimize energy consumption while ensuring comfortable temperatures, achieving green environmental protection for air source heat pumps.
Protect your home floor by activating the Floor Preheating function which slowly increases the heating temperature of the floor coils, avoiding possible floor damaging and transitioning smoothly to the heating function. The Floor Drying Up function provides an additional solution to the installer as it helps remove any residual moisture from newly installed floor coils, further protecting the installation and ensuring the optimal and effective operation of the heat pump.
More flexibility thanks to two control zones
Independent control of underfloor heating and radiator heating temperature
No need to purchase an extension module for second heating system
Smart design to work with other heating facilities in your house, like solar, gas boiler and etc, make sure you to pay the lowest bill for heating !
A heat pump system designed for a single area is intended to warm a small space, usually just one room. These systems consist of an outdoor unit that links to a single indoor unit, providing heating or cooling to the designated area.
If you only need to heat or cool a small part of your house, then a single-area heat pump system is the ideal choice. One common scenario where a single-area system is used is when you want to regulate the temperature in a newly built extension of your home, while the rest of the house is already equipped with a central air conditioning system. Although you have the option to install multiple single-area systems, if you want to heat or cool multiple rooms using air source heat pumps, it would be more energy-efficient to opt for a multi-area system.
A multi-zone heat pump system has the ability to warm and cool different parts of a house by using multiple units in various areas, all linked to a single outdoor unit. By installing a multi-zone system, you have the option to heat or cool different "zones" within your property at different temperatures simultaneously. For instance, during the scorching summer months, you can set the temperature of the room where you spend most of your time to a lower level, while other zones are set at a higher temperature to minimize your overall energy consumption.
English
