R290 Green Gas at low GWP(3)
Good SCOP, energy label rating W35℃ A+++/ W55℃ A++
Smart logic to control multiple heat source
Climate curves suitable for different countries
Hot water up to 75C, suitable for underfloor/radiator heating/fan coil
Full inverter system, Stable and efficient performance
Space heating Series is specially developed with the most cutting-edge heat pump technology and modern design to meet stringent requirements for efficiency, stability and quietness. Not only does Space heating Series use R290 green gas, but also is rated with A+++ energy label. With top energy rating A+++, the unit is energy efficient and can greatly reduce energy bills for users.
R290 is one of the best refrigerant available for mass production upto now: Negligible Global Warming Potential(GWP) and degradation time is considered in monthes
Zero ozone layer depletion potential(ODP)
Permanent green
Less load for the same performance
Low energy consumption and higher efficiency
By heating the water in the system to 65°C, the high temperature kills most bacteria (including Legionella).
Eco mode is an intelligent energy-saving mode that can minimize energy consumption while ensuring comfortable temperatures, achieving green environmental protection for air source heat pumps.
Protect your home floor by activating the Floor Preheating function which slowly increases the heating temperature of the floor coils, avoiding possible floor damaging and transitioning smoothly to the heating function. The Floor Drying Up function provides an additional solution to the installer as it helps remove any residual moisture from newly installed floor coils, further protecting the installation and ensuring the optimal and effective operation of the heat pump.
More flexibility thanks to two control zones
Independent control of underfloor heating and radiator heating temperature
No need to purchase an extension module for second heating system
Smart design to work with other heating facilities in your house, like solar, gas boiler and etc, make sure you to pay the lowest bill for heating !
Thorough preparation is crucial in order to achieve optimal cost-effectiveness when installing a heat pump, regardless of whether it is for a remodeling project or a brand-new building.
The coefficient of performance (COP) changes based on the outside temperature, decreasing its effectiveness during extremely cold weather. Nonetheless, air source heat pumps exhibit impressive performance throughout the year and have gained significant popularity in colder regions like Scandinavia.
Air source heat pumps are highly compatible with underfloor heating due to their ability to function at lower temperatures. At first, the costs associated with installing an underfloor heating system alongside a heat pump can appear substantial. Nonetheless, within the initial year of installation, you will notice a reduction in your electricity bill and experience enhanced comfort within your property. Depending on the specifics of your system and its location, it is possible to recoup the costs of your heat pump within a span of 12 years.
If you have radiators in your current heating system, you may want to think about using air to water heat pumps as well. If you prefer not to switch to underfloor heating, it is important to keep in mind that the effectiveness of the heat pump when combined with radiators relies on them being the right size for the heating needs. In this situation, larger or double-panel radiators would be the best choice.
R290 Green Gas at low GWP(3)
Good SCOP, energy label rating W35℃ A+++/ W55℃ A++
Smart logic to control multiple heat source
Climate curves suitable for different countries
Hot water up to 75C, suitable for underfloor/radiator heating/fan coil
Full inverter system, Stable and efficient performance
Space heating Series is specially developed with the most cutting-edge heat pump technology and modern design to meet stringent requirements for efficiency, stability and quietness. Not only does Space heating Series use R290 green gas, but also is rated with A+++ energy label. With top energy rating A+++, the unit is energy efficient and can greatly reduce energy bills for users.
R290 is one of the best refrigerant available for mass production upto now: Negligible Global Warming Potential(GWP) and degradation time is considered in monthes
Zero ozone layer depletion potential(ODP)
Permanent green
Less load for the same performance
Low energy consumption and higher efficiency
By heating the water in the system to 65°C, the high temperature kills most bacteria (including Legionella).
Eco mode is an intelligent energy-saving mode that can minimize energy consumption while ensuring comfortable temperatures, achieving green environmental protection for air source heat pumps.
Protect your home floor by activating the Floor Preheating function which slowly increases the heating temperature of the floor coils, avoiding possible floor damaging and transitioning smoothly to the heating function. The Floor Drying Up function provides an additional solution to the installer as it helps remove any residual moisture from newly installed floor coils, further protecting the installation and ensuring the optimal and effective operation of the heat pump.
More flexibility thanks to two control zones
Independent control of underfloor heating and radiator heating temperature
No need to purchase an extension module for second heating system
Smart design to work with other heating facilities in your house, like solar, gas boiler and etc, make sure you to pay the lowest bill for heating !
Thorough preparation is crucial in order to achieve optimal cost-effectiveness when installing a heat pump, regardless of whether it is for a remodeling project or a brand-new building.
The coefficient of performance (COP) changes based on the outside temperature, decreasing its effectiveness during extremely cold weather. Nonetheless, air source heat pumps exhibit impressive performance throughout the year and have gained significant popularity in colder regions like Scandinavia.
Air source heat pumps are highly compatible with underfloor heating due to their ability to function at lower temperatures. At first, the costs associated with installing an underfloor heating system alongside a heat pump can appear substantial. Nonetheless, within the initial year of installation, you will notice a reduction in your electricity bill and experience enhanced comfort within your property. Depending on the specifics of your system and its location, it is possible to recoup the costs of your heat pump within a span of 12 years.
If you have radiators in your current heating system, you may want to think about using air to water heat pumps as well. If you prefer not to switch to underfloor heating, it is important to keep in mind that the effectiveness of the heat pump when combined with radiators relies on them being the right size for the heating needs. In this situation, larger or double-panel radiators would be the best choice.
English
